# Body, Glass and Doors > Dents, panels, bumpers, fenders, compartment doors, entry doors, windshields and side window reseals for RVs, vans and trucks. Source: https://ocrv.info/services/body-glass-and-doors A recreational vehicle sidewall is not car sheet metal. Most coaches built in the last three decades use a laminated sandwich: an outer skin of filon fiberglass or painted aluminum, a foam or block insulation core, a lauan or Azdel substrate, and an interior wallboard, all pressed together with adhesive. Damage that looks cosmetic from ten feet away often means the bond between those layers has broken. Repair strategy starts with figuring out how deep the injury runs. The doors and glass on the same vehicle follow yet another set of rules. Entry doors hang on continuous hinges bolted into a framed opening that flexes as the coach moves. Baggage doors ride on gas struts and cam locks that were built to a weight budget. Windshields on a Class A sit in a urethane bead against a fiberglass cap, not a steel pinchweld. Each of those interfaces fails in its own way and each wants its own fix. OCRV Center works this category in shop at the Yorba Linda facility, roughly twenty miles from Eastvale by way of SR-71 and SR-91. The building runs 35,000 square feet, which matters here because a forty three foot coach with a windshield out needs to sit indoors, level, and undisturbed while adhesive cures. Owners across Riverside County bring motorhomes, fifth wheels, Sprinter conversions, box trucks and municipal units through the same bays. ## How is RV body repair different from automotive body repair? Scale changes the method. A car fender is a stamped steel part with a known replacement number and a two hour install. A motorhome sidewall may be a thirty eight foot continuous laminated panel with windows, service doors and slide openings cut into it. There is no bolt-on replacement. The work becomes a sectioning job: cut back to sound laminate, scarf the edges, bond in new substrate and skin, then fair the joint so it disappears under paint. Fastening is different too. Recreational vehicles are assembled with staples, screws, structural adhesive and butyl tape rather than spot welds. That means a body technician spends real time on sealant archaeology, scraping out old butyl and putty tape, before anything new goes on. It also means water is always part of the diagnosis. A dent low on a sidewall is a dent. The same dent at a window corner is a leak path that has probably been wet for a while. - Laminated sandwich walls instead of stamped panels - Adhesive, rivet and staple assembly rather than spot welds - Sealant joints that must be rebuilt, not just repainted - Repair sections sized to the damage, since full panels rarely exist - Moisture checks built into the estimate on any breach near a seam ## What does OCRV Center check before quoting body and glass work? The first pass is a hands-on survey of the damaged area and everything within two feet of it. Technicians tap and press the laminate to find where the bond ends, run a moisture meter through the interior wall behind the impact, and pull an interior trim piece when the reading is ambiguous. On glass, the frame gets checked for corrosion, soft substrate and prior sealant abuse before anyone quotes a replacement, because a windshield set into a rotten opening leaks again in a season. The second pass is parts reality. Many coach builders have stopped supporting older models, and a compartment door or a tinted side window may be discontinued. Sourcing determines schedule far more often than labor does, so the estimate names what is available, what is being fabricated in house, and what is being adapted from a current production part. Pricing traces to the posted bands on the prices page rather than a number invented at the counter. ## Services in this category - [Dent Removal](https://ocrv.info/services/body-glass-and-doors/dent-removal): Pushing, pulling and reshaping dented fiberglass, aluminum and steel panels back to contour with minimal refinishing. Range $500 to $4,500, 2 to 20 hours. - [Panel Replacement](https://ocrv.info/services/body-glass-and-doors/panel-replacement): Cutting out damaged sidewall, cap or skin sections and bonding in new laminate, then fairing and refinishing the joint. Range $750 to $12,000, 5 to 60 hours. - [Bumper Repair and Replacement](https://ocrv.info/services/body-glass-and-doors/bumper-repair): Straightening, welding, refinishing or replacing steel, aluminum and fiberglass bumpers on coaches, trailers and trucks. Range $500 to $5,500, 3 to 22 hours. - [Fender and Quarter Panel Repair](https://ocrv.info/services/body-glass-and-doors/fender-and-quarter-panel-repair): Repair and replacement of wheel-well skirts, rear quarters and lower body panels damaged by blowouts, curbs and road debris. Range $750 to $8,500, 4 to 35 hours. - [Compartment and Baggage Door Repair](https://ocrv.info/services/body-glass-and-doors/compartment-and-baggage-door-repair): Rehanging, resealing and rebuilding exterior storage doors including hinges, struts, locks and discontinued door assemblies. Range $200 to $1,800, 1 to 10 hours. - [Entry Door Repair](https://ocrv.info/services/body-glass-and-doors/entry-door-repair): Realigning, resealing and rebuilding RV entry doors including hinges, latches, frames, screens and delaminated slabs. Range $400 to $4,500, 2 to 20 hours. - [Windshield Replacement](https://ocrv.info/services/body-glass-and-doors/windshield-replacement): Removal and installation of one-piece and two-piece motorhome windshields with opening repair and controlled adhesive cure. Range $2,500 to $7,500, 6 to 18 hours. - [Window Repair and Reseal](https://ocrv.info/services/body-glass-and-doors/window-repair-and-reseal): Removing, rebedding and reinstalling RV side windows, plus glass replacement, seal repair and opening substrate work. Range $250 to $3,500, 1 to 14 hours. ## Frequently asked questions ### Can you fix a dent in my motorhome without repainting the whole side? Usually yes. If the paint film is unbroken and the substrate behind it is still bonded, we push or pull the dent back and blend the refinish into adjacent panel breaks. Full-side refinish only becomes necessary when the coach has a large graphic wrap that cannot be matched partway, or when the clear has oxidized so far that a new panel will never blend. ### My RV is twenty years old and the part is discontinued. Now what? That is a normal week here. For baggage doors and trim we fabricate: aluminum frame, matched skin, new hinge and lock hardware from a current supplier. For side glass we can often reuse the original pane in a new frame. For a full sidewall section we build the laminate ourselves. The estimate will state clearly which parts are original, which are aftermarket and which we are making. ### Do you handle insurance claims for body and glass damage? Yes. We write the estimate, photograph the damage, and communicate directly with your adjuster. Comprehensive claims for glass and collision claims for body damage are both common here. If a supplement is needed once teardown reveals hidden damage, we document it and submit it before proceeding rather than doing the work and arguing about it later. ### How long will my coach be at the shop? A single compartment door or a window reseal is often a one or two day visit. A bumper, fender or single panel section typically runs three to eight days depending on refinish. A windshield replacement needs the coach indoors overnight for adhesive cure. Multi-panel work with paint blending pushes into the two to four week range. We give a target date at authorization and update it if parts slip. ### Do you come out to Eastvale to do the repair? No. All work happens in shop at the Yorba Linda facility. Body, glass and door work needs controlled temperature, a level floor, dust management and paint booth access, none of which travel. Most Eastvale owners run SR-71 to SR-91 and are here in half an hour. Drop-off and pickup are scheduled so the coach is not sitting in the yard longer than the job needs. --- OCRV Center. 23281 La Palma Ave, Yorba Linda, CA 92887. (949) 799-3387. info@ocrvcenter.com. Serving Eastvale, California in Riverside County, about 20 miles from the shop. All work is performed in shop at the Yorba Linda facility. No mobile, roadside or on-site service is offered. Scope is body, paint, structural, fiberglass, interior and vehicle systems work. Engine rebuilds, transmission rebuilds, drivetrain work, DOT inspections and emission testing are not performed.